BUILDING THE RBA
8 SIMPLE AND EASY STEPS
Be sure your hands are clean.
Disassemble the RBA.
Place the coil’s leads between the posts and wrap them around the RBA’s posts. Once in place ensure the coil is aligned with the air flow. Make sure that the coil is NOT touching the base.
Seat the coils into their final position, secure them by tightening the screws, and finally cut the excess leads off.
Cut a strip of cotton for your wick. Not too big and also not too small.
Thread your cotton through the middle of your coil.
Cut the ends of your cotton wick at an angle and stuff them throughout the juice well.
ATTENTION: Check the resistance of your coils before firing them on any device and check them periodically to ensure that the resistance remains the same.